0

FIN EC

Online nápověda

Stromeček
Nastavení
Program:
Jazyk:

Envelope

This window contains properties of envelope of combinations or load cases. The envelope is the diagram of quantity (mainly internal forces), that shows the maximum and minimum values of certain quantity for all combinations (load cases) included in the envelope in any point of the structure.

Left part shows complete list of available combinations (load cases), that may be included in the envelope. The selection can be done with the help of check boxes in front of the combination numbers or with the help of buttons in the toolbar on the right side of the list. The toolbar contains following buttons:

All

  • Selects all combinations or load cases in the list.

None

  • Cancels the selection of combinations or load cases.

Inverse

  • Selects the combinations (load cases) that weren't selected and deletes the selection for combinations (load cases) that were selected.

Original

  • Sets the selection that was active during the opening this window.

Internal forces and Reactions

The frames "Internal forces" and "Reactions" contain the parameters for making the envelopes of internal forces and reactions. Only maximum, minimum or both extreme values may be shown in envelopes. The "Envelope key" defines, whether the envelope will be shown for all components (the option "All") or only for one component and other components will show only values in corresponding combination (or load case), where the maximum of key component appears.

Definition of envelope content

Vyzkoušejte si zdarma náš software.
Stáhněte si aktuální Edici zdarma.

Vyzkoušejte si GEO5 - software, který šetří váš čas.

Demoverze

Vyzkoušejte si zdarma
naše programy.

Výuková videa

Podívejte se na ovládání a práci s našimi programy v praxi.

Inženýrské manuály

Stáhněte si manuály s teoretickými i praktickými ukázkami použití programů.